Origin system troubleshooting.
March 1, 2023Problem 1. Unit fails to complete set-up cycle.Check that the origin subsystem is working (refer Q3 set-up mode). If not:-…How can I tell if the origin subsystem is working properly?
March 1, 2023In set-up mode: In operational mode:What gap is necessary between the origin marker face, and the cover of the unit?
March 1, 20235-10 mm is normally acceptable, but in the case of the following installations 2- 4mm is recommended:-How do I secure the mounting bracket for steel rack installations?
March 1, 2023It is advisable to use four separate weld points when mounting the bracket to the rack.My gate won’t operate.
March 1, 2023Are the green IRB and LCK LED’s lit? If not, determine why. When the gate is triggered, does the red…My gate opens, but then won’t close.
March 1, 2023Check that the green IRB LED is on. If not, find out why.When I go into set-up mode, L1 starts flashing once, then twice, then three times etc.
March 1, 2023Is the TRG LED illuminated? If so, find and remove the short circuit.Can a battery larger than 7A/H be used on CENTSYS battery operated gate systems?
March 1, 2023Yes. The larger the battery the more times the gate can be operated when a power failure occurs. For high…What is CONDOMINIUM mode?
March 1, 2023This is a mode of operation which is used typically in townhouse complexes or business sites where there could be…What is PIRAC mode?
March 1, 2023PIRAC is an abbreviation for Passive Infra Red Auto Close. It is a mode of operation which will cause the…
